Thermo-Flex
Plus is a heat transfer material suitable for most cotton,
cotton-polyester, wool, lycra, and other basic fabrics including
many athletic mesh fabrics. The self adhesive layer permits
high speed cutting, ultra-fine detail, and easy weeding. Cut
in mirror image through adhesive layer (dull side) to the
plastic backing. Weed the excess material and lay the cut
pattern on the fabric. Cover the design area with paper or
cloth release sheet. Irons can be used, but for best results,
a heat press is preferred at 340º-350ºF
for 20 seconds. When transfer is cool to the touch, peel away
backing sheet. Transferred image may be covered with a non-stick
sheet and re-heated if necessary. You should use firm or hard
pressure for proper transfer.
|
